"Poop Chute v2"

Many of these CoreXY printers have a "poop chute" for filament when they are starting up or doing filament changes between spools they purge a bit of filament out the back. This filament "poop" can add up quite a bit. So far it's been minimal for me because I haven't done any multi-color prints yet. This "Poop Chute" attaches to the printer and then holds the filament for easy organization/disposal.

I plan on collecting the filament and using silicone molds and melting the filament into something using the molds.

Printed "Chute". This is HS-PLA gray that came with the AnyCubic Kobra S1

Basket that holds the filament poop. HS-PLA Red (although in the picture it looks orange I promise it's red).

This is the basket that holds the filament. It's easily removable with the filament "poop". I've had it about a week or so and until now it's just fallen on the floor and I have to clean it up every day after printing.

It's hard to see but in the top right at the beginning of the chute there are two screws that go into the printer. They were already there holding the included chute on the inside of the printer. I just removed them (the inside chute doesn't move) and put the printed chute on the outside and screwed it back in and now it's secure.